0121
TM 1-1740-221-13&P&P
ELECTRIC PANEL (DASH) - (CONTINUED)
4.
Remove Time Delay Relay (Figure 1, Item 14) by pulling straight up while gently wiggling relay side to side.
PARK POSITION BRAKE ENGAGE RELAY (CRP)
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel (WP 0120).
3. Locate CRP relay (Figure 1, Item 13) referencing panel schematic decal.
4. Remove wiring connector (Figure 1, Item 12) from CRP Relay.
5. Slide CRP relay (Figure 1, Item 13) from its mount tang by pulling forward while gently wiggling relay side
to side.
PARK POSITION BRAKE DISENGAGE RELAY (CRR)
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel (WP 0120).
3. Locate CRR relay (Figure 1, Item 10) referencing panel schematic decal.
4. Remove wiring connector (Figure 1, Item 11) from CRR Relay.
5. Slide CRR relay (Figure 1, Item 10) from its mount tang by pulling forward while gently wiggling relay side
to side.
CAPACITOR (SERVICE BRAKE SYSTEM FAIL) (CAP-1)
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel (WP 0120).
3. Locate service brake system fail capacitor referencing schematic decal or (Figure 1, Item 8).
4. Loosen 2 set screws (Figure 1, Item 7).
5. Remove capacitor (Figure 1, Item 8) noting positive lead is in the top position.
ACCESSORY FUSES
1. Electric Panel Fuse Identiication (Figure 1, Item 9A, B, C, D, E and F)
9A Fuse 3FU 30 Amp Run Circuit
9B Fuse 4FU 5 Amp Engine Start
9C Fuse 7FU 5 Amp Gauges and Senders
9D Fuse 6FU 5 Amp Hand Brake Relay
9E Fuse 5FU 10Amp Transmission ECU
9F Fuse 8FU 5 Amp Fuel Solenoid, Glow Plugs
2.
Disconnect battery negative cables (WP 0111).
3.
Open dash panel (WP 0120).
4.
Locate fuse to be replaced referencing (Figure 1, Item 9A, B, C, D, E and F) or electric panel schematic label.
5.
Remove defective fuse.
END OF TASK
INSTALLATION
ACCESSORY RELAY (CRA)
1. Position accessory relay (Figure 1, Item 15).
2. Install 2 washers and nuts (Figure 1, Item 5) (one not shown) and tighten.
3. Install wire (Figure 1, Item 4) on relay.
01213