0120
TM 1-1740-221-13&P&P
DASH PANEL - (CONTINUED)
2.
Secure appropriate switch (Figure 1, Item 14 or 16) with star washer and nut.
3.
Position 2 wires and secure with two screws (Figure 2, Item 8 or 11).
4.
Close dash panel.
5.
Connect battery negative cables (WP 0111).
6.
Perform Maintenance Operation Check.
GAUGE LIGHT DIMMER REHOSTAT
1. Position rheostat (Figure 2, Item 10) in dash panel.
2. Secure rheostat switch (knob removed) (Figure 1, Item 13) with star washer and nut.
3. Solder wires to rheostat (Figure 2, Item 10) terminals.
4. Close cover and install rheostat switch knob (Figure 1, Item 13) and tighten set screw in knob.
5. Connect battery negative cables (WP 0111).
6. Perform Maintenance Operation Check.
GAUGE LIGHT
1. Place LED (Figure 1, Item 18) in holder (Figure 1, Item 19) push LED in then twist to lock in place.
2. Push appropriate gauge light assembly (Figure 2, Item 13) into the appropriate gauge and secure.
3. Close dash panel.
4. Connect battery negative cables (WP 0111).
5. Perform Maintenance Operation Check.
TURN SIGNAL FLASHER RELAY
1. Carefully push signal lasher relay (Figure 3, Item 7) into relay socket.
2. Close dash panel.
3. Connect battery negative cables (WP 0111).
4. Perform Maintenance Operation Check.
01208