0120
TM 1-1740-221-13&P&P
DASH PANEL - (CONTINUED)
GAUGE LIGHT DIMMER RHEOSTAT
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel.
3. De-solder four wires (Figure 2, Item 10). Note orientation of rheostat secured to panel.
4. Close cover. Remove rheostat switch knob (Figure 2, Item 13) by loosening set-screw and removing knob.
5. Remove locknut and star washer from rheostat and remove rheostat from dash panel.
GAUGE LIGHT
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel.
3. Pull appropriate gauge light assembly (Figure 2, Item 13) from the appropriate gauge.
4. Push in on LED (Figure 1, Item 18) and twist to release from holder (Figure 1, Item 19).
5. Remove defective LED.
TURN SIGNAL FLASHER RELAY
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel.
3. Carefully pull turn signal lasher relay (Figure 3, Item 7) from the relay socket.
4. Remove defective lasher relay.
TRANSMISSION CIRCUIT FUSE (20 AMP)
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel.
3. Remove fuse boot cover (Figure 3, Item 1).
4. Remove defective fuse (Figure 3, Item 3) from fuse holder (Figure 3, Item 2).
RECTIFIER DIODE, PARK BRAKE ENGAGE (REC2)
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel.
3. Pull diode REC2 (Figure 3, Item 4) from diode holder (Figure 3, Item 5).
4. Remove defective diode.
RECTIFIER DIODE, REVERSE (BACKUP) LIGHT (REC1)
1. Disconnect battery negative cables (WP 0111).
2. Open dash panel.
3. Remove diode REC1 (Figure 3, Item 6) from wiring harness quick disconnects.
END OF TASK
INSTALLATION
INDICATOR LENS AND BULB
1. Install bulb (Figure 1, Item 12) in appropriate lens cover (Figure 1, Item 11).
2. Install appropriate lens/bulb assembly (Figure 1, Item 1 through 6) by screwing lens into appropriate position.
3. Connect battery negative cables (WP 0111).
4. Perform Maintenance Operation Check.
LIGHT (INDICATOR) HOLDER
1. Install appropriate light holder (socket) (Figure 2, Item 14) in appropriate position on panel.
2. Install lock nut and star washer on light holder (socket) (Figure 2, Item 14).
01206