TM 1-1270-476-30
4-159
4-9. BRANCHED WIRING HARNESS ASSEMBLY (W10) REPAIR (cont)
3. CONNECTOR P13 REPLACEMENT
REMOVAL
CAUTION
Use care not to damage wires and flexible
cabling attached to the scanner optics
assembly when mounting hardware is
removed.
a. Remove screw (1), washer (2), and loop
clamp (3) from scanner optics assembly
(4).
(1) Disconnect connector P3 (5) from
scanner optics assembly connector
A32J1 (6) by loosening screwlocks (7).
NOTE
Two people required to perform steps a (2)
thru c.
(2) While manually supporting scanner
optics assembly, remove four
capscrews (8) and washers (9). (Use
hex key T1 to remove lower right-hand
screw.) Carefully move scanner optics
assembly (4) up and out enough to get
screwdriver on screw (10).
b. Disconnect connector P13 (11) from
connector A32RT1J1 by removing screw
(10) securing connector P13.
c. Secure scanner optics assembly (4) by
installing four capscrews (8) and washers
(9). (Use hex key T1 to install lower right-
hand screw.)
d. Remove connector P13 (11) from wires
(para 2-5).
INSTALLATION
e. Install replacement connector P13 (11) on
wires (para 2-5).
