0064
TM 1-1740-221-13&P&P
FUEL TANK SENDING UNIT (FUEL GAUGE) - (CONTINUED)
REMOVE
WARNING
The use of Personal Protective Equipment (PPE) is required when using or handling hazardous
materials associated with operating and maintaining equipment (jet fuel, hydraulic luid, brake
luid, ethylene glycol, cleaning solvents, compressed air, and engine/axle oil). Failure to use
PPE when handling these materials could result in injury or death.
NOTE
Tag wiring to aid with the reinstallation process.
Figure 2. Fuel Sending Unit (Removal and Installation)
1.
Remove rear deck plate (WP 0028).
2.
Disconnect battery cables (WP 0111).
3.
Remove terminal mount screw (Figure 2, Item 3) and wire (Figure 2, Item 4).
4.
Remove fuel level sending unit mount screw (Figure 2, Item 5) and ground wire (Figure 1, Item 6).
5.
Remove remaining four fuel level sending unit mount screws (Figure 2, Item 2).
6.
Carefully remove fuel level sending unit (Figure 2, Item 1) and gasket (Figure 2, Item 7).
7.
Clean fuel level sending unit mating surfaces.
8.
Test fuel level sending unit this work package.
END OF TASK
INSTALLATION
NOTE
Fuel sender mount holes will only line up in one way.
1.
Position new gasket (Figure 2, Item 7) on fuel tank.
2.
Position fuel level sending unit (Figure 1, Item 1).
3.
Position ground wire #7 (Figure 2, Item 6).
00642