0065
TM 1-1740-221-13&P&P
FUEL SYSTEM SERVICING - (CONTINUED)
4.
After seal or gasket contacts sealing surface, tighten by hand an additional 3/4 turn. Avoid over-tightening
fuel ilter.
5.
Perform air bleeding the fuel system this Work Package.
1
3
2
4
5
12
11
6
5
4
10
9
8
WP0056F2
7
Figure 2. Fuel Filter/Water Separator Assembly
FUEL/WATER SEPARATOR FILTER
1. Install new ilter (Figure 2, Item 9) onto bowl ensuring seal is in the bowl housing slot and hand tighten.
2. Fill fuel/water separator assembly with fuel and lubricate ilter seal with clean fuel.
3. Install fuel ilter/bowl assembly by hand onto ilter housing (Figure 2, Item 11).
4. When separator assembly seal contacts the mating surface tighten by hand an additional 3/4 turn.
5. Install fuel heater wiring (Figure 2, Item 6) onto bowl receptacle connector.
6. Perform air bleeding the fuel system this Work Package.
7. Connect battery cable (WP 0111).
FUEL/WATER SEPARATOR HOUSING ASSEMBLY
1. Position fuel ilter/water separator (Figure 2, Item 11).
2. Secure using two bolts, washers, and nuts (Figure 2, Item 1). with ground wire (Figure 2, Item 12).
3. Clean ittings (Figure 2, Item 5) and apply anti seizing tape to the threads.
00654
