0063
TM 1-1740-221-13&P&P
FUEL TANK - (CONTINUED)
INSTALLATION
1. Carefully position fuel tank (Figure 1, Item 13) in tank compartment.
2. Position straps over fuel tank (Figure 1, Item 6).
3. Secure one end of straps with two bolts and nuts (Figure 1, Item 11 and 12).
4. Secure other end of straps with two bolts, nuts and washers (Figure 1, Item 7, 8 and 9).
NOTE
If fuel tank is being replaced proceed to Step 7, repaired proceed to Step 5.
5.
Carefully install sender (Figure 1, Item 3) and new gasket (Figure 1, Item 15) and secure with ive screws
(Figure 1, Item 1).
6.
Apply Telon tape to the two fuel ittings (Figure 1, Item 4) and install in tank assembly in the same position
as removed.
7.
Remove fuel line plugs and connect both fuel lines (Figure 1, Item 14) at fuel tank and secure with clamps.
8.
Apply anti-seize tape to threads of fuel tank drain plug (Figure 1, Item 10) and install securely in tank.
9.
Service tank (Figure 1, Item 13) with fuel and install cap (Figure 1, Item 5).
10.
Connect tagged fuel sender wiring (Figure 1, Item 2) and secure with hardware.
11.
Bleed air from fuel lines (WP 0065).
12.
Install rear deck plate support (WP 0028).
13.
Connect battery cables (WP 0111).
14.
Perform Maintenance Operation Check.
15.
Install rear deck plate and middle deck plate (WP 0028).
END OF TASK
END OF WORK PACKAGE
00633/blank