TM 1-1500-204-23-11
(1) Facilities, Equipment and Material. follow-
Liquid (See System Speciic Technical Manual), Adhe-
ing equipment and materials are required: Vacuum
sive, Paste (See System Speciic Technical Manual),
Cleaner HEPA Filter, Dual Action Sander, Drill Motor,
Release Liquid, Vacuum Bag Repair Materials Kit,
2000 RPM, Drill Bit, 1/8 Inch Diameter, 90 Degree
High Temperature Tape, Dry Woven Cloth, (See Sys-
Router Motor, 20,000 RPM, 0 Degree Router Motor,
tem Speciic Technical Manual), Patch (See System
20,000 RPM, Overhose Assembly, Router Holder,
Speciic Technical Manual), Release Film, Acetate,
Temporary Fasteners, Sanding Disks, 80, 150 &
Clear, Aluminum Sheet Stock, 0.063 inches or thicker
180 Grit, 1.0 & 2.0 Inch Diameter, Sanding Disk
(Local Procurement).
Holder, Repair Rib Tool (Local Manufacture), Cutting
Wheel, Diamond Coated, 80 Grit, 1.0 Inch Diame-
(2) Trailing Edge Repair Procedure. Typical
ter, Clamps, Heat Blanket, Temperature/Vacuum Con-
steps required to rebuild damaged corners are shown
troller, Weights, Shot Bags, Marking Pen, Scissors,
in igure 7-47.
Heat Lamp, Adhesive Comb, DVD tool, Silicon Car-
bide Abrasive Paper, Wiping cloth, Spatula, Adhesive,
7-77
