0101
TM 1-1740-221-13&P&P
CREW PROTECTION SYSTEM (CPS) WIPER MOTOR - (CONTINUED)
1
2
8
3
7
6
5
4
SATSCPSab0010
Figure 1.
Wiper Motor Assembly
END OF TASK
INSTALLATION
1. Connect wiper arm link (Figure 1, Item 5) to wiper motor assembly (Figure 1, Item 3) and secure with
retaining clip (Figure 1, Item 6).
2. Install wiper motor assembly shaft through CPS cab and secure to cab with two allen head screws
(Figure 1, Item 8) and two washers (Figure 1, Item 7) from exterior.
3. Install jam nut (Figure 1, Item 2) on shaft and tighten, then install rubber boot (Figure 1, Item 1) on jam nut.
4. Reconnect CPS wiring harness (Figure 1, Item 4) to wiper motor connector (Figure 1, Item 4).
5. Secure washer tubing to wiper motor assembly (Figure 1, Item 3) with one tie-strap.
6. Install passenger side wiper arm (WP 0099).
7. Perform Maintenance Operation Check.
8. Close CPS dash (WP 0098).
END OF TASK
END OF WORK PACKAGE
01012