0049
TM 1-1740-221-13&P&P
SOLENOID VALVE (3-POSITION/SINGLE SOLENOID) - (CONTINUED)
Figure 5. Solenoid (Four Wheel Drive) Coil Test
4-Wheel Drive Solenoid Valve Coil and Spool
NOTE
Removal of the coil from the spool may be necessary to allow for installation of the spool
assembly.
1.
Position spool assembly (Figure 5, Item 5) in transmission.
2.
Turn spool mount nut (Figure 5, Item 4) clockwise and tighten.
3.
Install solenoid coil (Figure 5, Item 3).
4.
Install solenoid plates with crush-ring (Figure 5, Item 2).
5.
Apply Loctite 242 to the coil mount nut (Figure 5, Item 1) threads.
6.
Install coil mount nut (Figure 5, Item 1) and torque to 4-6 ft. lbs.
7.
Connect 4-wheel drive solenoid wiring connector (same as (Figure 2, Item 1).
8.
Connect battery negative cables (WP 0111).
9.
Perform Maintenance Operation Check.
10.
Install center deck plate (WP 0028).
Solenoid Valve Assembly
1. Install appropriate solenoid valve assembly (Figure 1, Item 4) on transmission.
2. Install 4 mount bolts (Figure 1, Item 1) and tighten.
3. Connect appropriate solenoid wiring connector (Figure 2, Item 1).
4. Connect battery negative cables (WP 0111).
5. Perform Maintenance Operation Check.
00498