0049
TM 1-1740-221-13&P&P
SOLENOID VALVE (3-POSITION/SINGLE SOLENOID) - (CONTINUED)
1.
Disconnect battery negative cables (WP 0111).
2.
Remove center deck plate (WP 0028).
3.
Disconnect appropriate solenoid wiring connector (Figure 2, Item 1).
4.
Place a drip pan under the solenoid valve assembly.
5.
Remove 4 mount bolts (Figure 1, Item 1).
6.
Remove appropriate solenoid valve assembly (Figure 1, Item 4).
END OF TASK
INSTALLATION
Solenoid Valve Coils
NOTE
Apply a thin coat of transmission luid on O-rings.
1.
Install O-ring (Figure 4, Item 4) in valve body groove.
2.
Position solenoid coil (Figure 4, Item 3).
3.
Install O-ring (Figure 4, Item 2).
4.
Apply Loctite 242 to the knurled nut threads (Figure 4, Item 1).
5.
Install knurled nut (Figure 4, Item 1) and snug tight (do not over tighten).
6.
Connect appropriate solenoid wiring connector (Figure 2, Item 1).
7.
Connect battery negative cables (WP 0111).
8.
Perform Maintenance Operation Check.
9.
Install center deck plate (WP 0028).
00497