0049
TM 1-1740-221-13&P&P
SOLENOID VALVE (3-POSITION/SINGLE SOLENOID) - (CONTINUED)
NOTE
This removal and installation procedure is the same on all 6 upper or lower solenoid coils.
1.
Disconnect battery negative cables (WP 0111).
2.
Remove center deck plate (WP 0028).
Figure 4. Solenoid Valve Coil (Removal and Installation)
3.
Disconnect appropriate solenoid wiring connector (Figure 2, Item 1).
4.
Remove knurled nut (Figure 4, Item 1).
5.
Remove O-ring (Figure 4, Item 2).
6.
Remove solenoid coil (Figure 4, Item 3).
7.
Remove O-ring (Figure 4, Item 4).
4-WHEEL DRIVE SOLENOID VALVE COIL AND SPOOL
1. Disconnect battery negative cables (WP 0111).
2. Remove center deck plate (WP 0028).
3. Disconnect 4-wheel drive solenoid wiring connector (same as (Figure 2, Item 1).
4. Remove coil mount nut (Figure 5, Item 1).
5. Remove solenoid plates with crush-ring (Figure 5, Item 2).
6. Remove solenoid coil (Figure 5, Item 3).
00495