0038
TM 1-1740-221-13&P&P
OIL PRESSURE SENDING UNIT (GAUGE) - (CONTINUED)
REMOVAL
1
2
3
7
6
4
5
WP0030F1
Figure 1. Oil Pressure (Gauge) Sending Unit (Removal and Installation)
1.
Disconnect negative battery cables (WP 0111).
2.
Open engine cover (WP 0028).
3.
Remove nut (Figure 1, Item 4) from sending unit stud (Figure 1, Item 3).
4.
Remove wire (Figure 1, Item 1).
5.
Loosen bolt (Figure 1, Item 2) securing loop clamp (Figure 1, Item 6) to lywheel housing.
6.
Slide oil pressure sending unit from loop clamp.
WARNING
To avoid personal injury, ensure engine is stopped and has cooled prior to removing the oil
pressure sending unit.
7.
Remove oil pressure sending unit (Figure 1, Item 5)
END OF TASK
INSTALLATION
1. Wrap threads of oil pressure sending unit (Figure 1, Item 5) with anti-seize tape.
CAUTION
To avoid damage to oil pressure sending unit, do not over-tighten.
2.
Install oil pressure sending unit (Figure 1, Item 5).
3.
Position oil pressure sending unit into loop clamp (Figure 1, Item 6).
4.
Tighten bolt (Figure 1, Item 2).
5.
Install wire (Figure 1, Item 1).
00382