TM 1-1740-221-13&P&P
FIELD MAINTENANCE
STARTER
INITIAL SETUP:
Personnel Required
Test Equipment
91B, Light Wheel Vehicle Mechanic
Multimeter (WP 0157, Item 14)
References
Tools and Special Tools
General Mechanic Tool Box (WP 0157, Item 24)
Torque Wrench, 100 inch pound (WP 0157, Item 25)
INSPECTION
Visually inspect starter assembly mounting security, wiring for loose connections, breaks in insulation or any
damage affecting serviceability.
END OF TASK
TEST
WARNING
Remove all jewelry such as rings, ID tags, watches, and bracelets. If jewelry or tools contact a
battery positive terminal, a direct short will result in instant heating or electric shock, damage to
equipment, and injury to personnel.
NOTE
Perform voltage test at starter solenoid terminal (Figure 1, Item 6) ensuring 12 volts are
present. Ensure starter mount is properly grounded.
STARTER TEST
1. Remove wire from starter solenoid (Figure 1, Item 7).
2. Using 12-gauge wire (approximately 6 inches long), briely jump 12 volts from starter solenoid terminal
(Figure 1, Item 6) to solenoid terminal (Figure 1, Item 7). Starter should engage.
3. Replace starter if test fails.
END OF TASK
00341