0031
TM 1-1740-221-13&P&P
POWER PACK ASSEMBLY - (CONTINUED)
NOTE
The two rear mount bolts will be installed after wire and hose routing is complete.
5.
Install front two bolts, four washers and two nuts (Figure 5, Item 1) torque nuts to 78 ft. lbs..
6.
Remove slings.
7.
Connect air intake tube assembly (WP 0071).
8.
Route brake hoses and throttle reservoir back to connection location.
9.
Install brake reservoirs (WP 0083).
10.
Connect throttle reservoir to irewall (WP 0127).
11.
Route main brake line and hand brake cable over radiator mount and along frame under tabs.
NOTE
Do not bend hose and cable chassis tabs down at this time.
12.
Connect main brake line to rear axle tee (WP 0084).
13.
Connect hand brake cable to hand brake caliper bracket (WP 0089).
14.
Bend tabs down to secure hand brake cable.
15.
Connect the slave cylinder supply hose to throttle slave cylinder assembly (WP 0125).
16.
Route hydraulic hoses back to connection locations.
17.
Connect hydraulic pressure line to gear pump (WP 0135).
18.
Connect hydraulic tank return line to tank (WP 0131).
19.
Uncoil transmission ECU wire harness and feed to front of vehicle and plug into the rear of ECU (WP 0048).
003110