0031
TM 1-1740-221-13&P&P
POWER PACK ASSEMBLY - (CONTINUED)
Figure 4. Engine Wiring Harness Clamp on Bell Housing
42.
Disconnect engine block ground nut and wire (Figure 3, Item 1 and 2).
43.
Remove engine wiring harness clamp (Figure 4, Item 1) from bell housing.
44.
Pull positive battery cable from chassis.
45.
Pull all wires from engine power pack.
46.
Pull all engine pack wiring over axle to front of vehicle.
47.
Disconnect rear transmission plug wire from ECU (WP 0048).
48.
Coil ECU wire harness and secure to transmission.
NOTE
Place drip pan under or shop towels at the appropriate location to collect draining hoses and
components.
49.
Disconnect hydraulic return hose from hydraulic tank (WP 0131).
50.
Disconnect hydraulic pressure hose from gear pump (WP 0135).
51.
Pull both hoses over axle to front of vehicle.
52.
Disconnect the hose from throttle slave cylinder assembly (WP 0125).
53.
Disconnect main brake hose from rear axle tee and pull to front of vehicle, routing over front axle (WP 0084).
00315
