TM 1-1270-476-30
4-20
4-2. TADS TURRET ASSEMBLY REPLACEMENT (cont)
al. Remove radar jammer support cover from
replacement turret (TM 1-1270-476-20).
am.Remove radar jammer transmitter antenna
(103) from defective turret assembly and
install on the replacement turret assembly
(TM 11-1520-238-23-1).
an. Install radar jammer support cover on
defective turret (TM 1-1270-476-20).
ao. Disconnect brake release power supply
assembly (104) from each turret assembly.
NOTE
This procedure is for disconnecting brake
release power supply assembly from either the
replacement turret assembly or the defective
turret assembly.
(1) Set POWER switch (105) to OFF.
(2) Disconnect connector P2 (106) from
connector J1 (107) on rear of turret
assembly (108).
(3) Disconnect connector P1 (109) from
connector J4 (110) on rear of turret
assembly (108).
(4) Disconnect connector P3 (111) from
connector J1 (112) on brake release
power supply assembly (104).
14. Move lifting device into work area.
15. Install universal sling assembly (4 above) on
replacement assembly.
