TM 1-1270-476-304-174-2. TADS TURRET ASSEMBLY REPLACEMENT (cont)k. Remove day sensor shroud assembly (80) from defective turret assembly (TM 1-1270-476-20) and place on clean surface.l. Loosen two screwlocks (81) and disconnect connector 1A4W1J1 (82) from connector 1A5W1P1 (83) on day sensor assembly (84).m. Loosen two screwlocks (85) and disconnect connector 1A4W1J3 (86) from connector 1A5W1P2 (87) on day sensor assembly (84).n. Loosen two screwlocks (88) and disconnect connector 1A4W1P11 (89) from connector 1A5A1A1J1 (90) on range receiver assembly (91).o. Disconnect connector 1A4W1P10 (92) from connector 1A5A1J1 (93) on LTU assembly (94).CAUTION• The day sensor assembly is bulky and fragile. Assistant is needed to support the assembly to prevent damage.• Optics are exposed when day sensor assembly is removed. Do not touch or bump optics. Damage will result.• Damage to the gimbal clamp assembly can result if the clamp pin is loosened too far. Loosen gimbal clamp assembly only far enough to allow the day sensor assembly to be removed.p. Loosen gimbal clamp assembly (95) by unscrewing clamp pin (96). Have assistant support day sensor assembly (84).q. Remove day sensor assembly (84) by unscrewing clamp pin (96) enough to spread clamp assembly (95).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business