TM 55-1680-320-23 & P
2-62. LEVEL WIND SHOE - REPLACE (cont)
2-62
a.
b.
c.
d.
e.
Remove chain guard cover (1) by removing
screws (2) and washers (3).
NOTE
Prior to disconnecting chain (4) from
limit switch drive assembly, mark
sprockets of drive assembly and winch
housing to preserve timing and prevent
need for adjustment.
Remove chain (4) by removing master link.
Remove lockwire from screws (5) and discard.
Remove screws (5, 6), washers (7, 8) and nuts
(9).
Carefully remove assembled drum cover (10)
and cable drum (11) from winch housing (12).
Remove retaining ring (13) and shim (14),
Using holding screw, AN3H26A, remove
retainer (15) and level wind shoe (16) from
drum (11).
2. Installation.
a.
b.
c.
d.
e.
Using a 10-32 screw, install level wind shoe
(16) and retainer (15). Install shims (14) to
obtain an axis end play of .004 to .008 in.
between shoe and retainer.
Install retaining ring (13) into drum assembly.
Align matched curved surfaces.
Position drum assembly (11) near flush with
drum cover (10) by rotating drum in relation
to cover.
Lower assembled drum (11) and cover (10)
into winch housing (12). Ensure proper align-
ment of drum shaft and drum drive gear splines.
Align cover (10) to housing (12) and secure
using screws (5, 6), washers (7, 8) and nuts
(9). Torque screws to 12.15 in.lbs.
GO TO NEXT PAGE
2-132
