TM 55-1680-320-23&P
2-128 Change 8
2-60. HOIST CABLE ASSEMBLY - REPLACE (cont)
2-60
m. Raise cable roller assembly and feed cable
through cable cutter and over sheave.
2. Installation
WARNING
DELETED
CAUTION
Protect hoist cable from damage. Do not
allow kinks or bends to occur. Maintain
hook weight on cable at all times.
a. Connect 28 vdc to hoist. Position control pen-
dant switch to UP
b. Reel hoist until drum has moved all the way
toward breather side and has started to return.
Position drum with cable shoe up and until
approximately 1/4 inch of drum flange is vis-
ible.
c. Disconnect electrical power
d. Install cable (14) through actuator arm and
cable guard. Raise roller assembly (17) and
insert cable over sheave assembly. Pull
approximately 4 feet of cable between roller
and sheave assemblies. Insert cable through
cable cutter.
e. Insert cable into winch housing (15). Wrap
cable once around cable drum (16). Insert
cable ball into cable retainer (12).
f. Install retainer (12) using holding screw,
AN3H26A (13) to align retainer to drum (16)
Ensure cable (14) is seated in proper groove.
Tighten setscrew. Remove screw (13).
GO TO NEXT PAGE
