0125
TM 1-1740-221-13&P&P
THROTTLE SLAVE CYLINDER ASSEMBLY AND VALIDATION SWITCH - (CONTINUED)
NOTE
If removing the ball joint (Figure 1, Item 5) note the number of threads inside of cylinder rod
mount during removal to aid in reinstallation.
1.
Chock wheels.
2.
Disconnect negative battery cables (WP 0111).
3.
Open engine access cover (WP 0028).
4.
Place a drip pan under slave cylinder.
5.
Remove slave cylinder supply hose (Figure 1, Item 8) and plug.
6.
Remove hose itting (Figure 1, Item 7) and save for reinstallation.
7.
Remove nut and washer (Figure 1, Item 4) from back of bracket.
8.
Remove slave cylinder mount nut (Figure 1, Item 9) and lat washer (Figure 1, Item 10).
9.
Remove slave cylinder (Figure 1, Item 6).
Throttle Validation Switch
1. Disconnect battery negative cables (WP 0111).
2. Open engine cover (WP 0028).
3. Remove 2 wire mount screws (Figure 1, Item 2) (1 not shown).
4. Remove 2 switch wires (Figure 1, Item 1).
5. Remove 2 switch mount screws and nuts (Figure 1, Item 3) (1 not shown).
6. Remove validation switch assembly.
END OF TASK
INSTALLATION
1. Place inside washer (Figure 1, Item 10) over rear mount stud.
2. Slide slave cylinder (Figure 1, Item 6) over rear mount stud and place ball joint (Figure 1, Item 5) into
mount bracket.
3. Install nut and washer (Figure 1, Item 4) to back of bracket to secure ball joint to mount bracket.
4. Install slave cylinder mount washer (Figure 1, Item 10) and nut (Figure 1, Item 9) and tighten.
5. Wrap hose itting (Figure 1, Item 7) with anti-seize tape and install.
6. Install slave cylinder supply hose (Figure 1, Item 8) and tighten.
7. Perform throttle system bleeding (WP 0124).
8. Connect battery negative cables (WP 0111).
9. Perform Maintenance Operation Check.
10. Close engine access cover (WP 0028).
Throttle Validation Switch
1. Position the validation switch assembly.
2. Install 2 switch mount screws and nuts (Figure 1, Item 3) (1 not shown) and tighten.
3. Position 2 switch wires (Figure 1, Item 1).
4. Install 2 wire mount screws (Figure 1, Item 2) (1 not shown) and tighten.
5. Close engine cover (WP 0028).
6. Connect battery negative cables (WP 0111).
7. Perform Maintenance Operation Check.
END OF TASK
END OF WORK PACKAGE
01252