0123
TM 1-1740-221-13&P&P
ELECTRIC PANEL (CENTER CONSOLE) - (CONTINUED)
2.
Remove driver and passenger seats (WP 0096).
3.
Remove center console panel (WP 0028).
4.
Removing fuse cover (Figure 1, Item 1).
5.
Remove fuse (2FU) (Figure 1, Item 18).
GLOW PLUG CIRCUIT BREAKER (CB1)
NOTE
Removal and installation of terminal protective boots is necessary to perform removal of glow
plug circuit breaker.
1.
Disconnect battery negative cables (WP 0111).
2.
Remove center console panel (WP 0028).
3.
Remove nuts and washers from terminal posts (Figure 1, Item 7) and remove wires.
4.
Remove two mount bolts (Figure 1, Item 6) and attaching nuts.
5.
Remove CB1 (Figure 1, Item 8) from center console.
GLOW PLUG RELAY (CRGP)
1. Disconnect battery negative cables (WP 0111).
2. Remove center console panel (WP 0028).
3. Remove nuts and washers (Figure 1, Item 10 and 12).
4. Remove wires from glow plug relay (Figure 1, Item 17).
5. Remove 2 relay mount bolts (Figure 1, Item 11) and attaching hardware.
6. Remove glow plug relay (Figure 1, Item 13).
STARTER (ENGINE) RELAY (SR)
1. Disconnect battery negative cables (WP 0111).
2. Remove center console panel (WP 0028).
3. Remove nuts and washers (Figure 1, Item 15 and 16) from electrical terminals.
4. Remove wires from starter relay.
5. Remove 2 starter relay mount bolts (Figure 1, Item 14) and attaching hardware.
6. Remove starter relay (Figure 1, Item 13).
END OF TASK
INSTALLATION
POWER FUSE (2FU)
1. Install fuse (2FU) (Figure 1, Item 18).
2. Install fuse cover (Figure 1, Item 1).
3. Connect battery negative cables (WP 0111).
4. Perform Maintenance Operation Check.
5. Install center console panel (WP 0028).
GLOW PLUG CIRCUIT BREAKER (CB1)
1. Position CB1 (Figure 1, Item 8) on mount panel.
2. Install two mount bolts (Figure 1, Item 6) and attaching nuts and tighten.
3. Install 2 wires on the terminal posts (Figure 1, Item 7).
4. Install washers and nuts on terminal posts (Figure 1, Item 7) and tighten.
01234