0085
TM 1-1740-221-13&P&P
PARK POSITION MOTOR (LINEAR ACTUATOR) - (CONTINUED)
PARK POSITION MOTOR/SWITCH INSTALLATION TEST/ADJUSTMENT
2
1
3
7
6
5
WP0076F2
4
Figure 2. Park Position Motor Installation Test
1.
Hand brake disengaged or off.
2.
Turn ignition switch on with transmission shifter in park.
3.
Move the transmission shifter to neutral (5 seconds) then back to park.
4.
The actuator will retract, engaging the park position caliper (Figure 2, Item 5).
5.
Bevel washers (Figure 2, Item 1) will compress actuating the upper limit switch.
6.
Upper limit switch actuation opens the switch de-energizing the park position motor.
7.
Adjust upper limit switch to open at point of washer compression.
8.
Move gear shifter to any position other than park.
9.
Actuator will extend and release park position caliper (Figure 2, Item 6).
10.
Bottom clevis will actuate the lower limit switch and de-energize the park position motor.
11.
Adjust lower limit switch as necessary by moving the limit switch actuator arm.
END OF TASK
END OF WORK PACKAGE
00853/blank