0085
TM 1-1740-221-13&P&P
PARK POSITION MOTOR (LINEAR ACTUATOR) - (CONTINUED)
2.
Remove center access panel (WP 0028).
3.
Disconnect electrical connector (Figure 1, Item 13).
4.
Remove shoulder bolt (Figure 1, Item 7) and nut (Figure 1, Item 14).
NOTE
Support park position motor actuator shaft from dropping when top clevis is removed.
5.
Remove bolt (Figure 1, Item 5), washer (Figure 1, Item 12) and nut (Figure 1, Item 11).
6.
Remove clamp (Figure 1, Item 10).
7.
Remove cotter pin (Figure 1, Item 1).
8.
Support park position motor and remove clevis pin (Figure 1, Item 3).
9.
Remove park position motor (linear actuator) (Figure 1, Item 9).
END OF TASK
INSTALLATION
NOTE
If replacing park position motor, remove bottom clevis from linear actuator and retain for
reinstallation.
1.
Attach bottom clevis (Figure 1, Item 8) to park position actuator rod (if necessary).
2.
Align park position motor (Figure 1, Item 9) onto park position mount bracket (Figure 1, Item 14).
3.
Install clevis pin (Figure 1, Item 3).
4.
Install cotter pin (Figure 1, Item 1).
5.
Install clamp onto motor (Figure 1, Item 10).
6.
Install bolt (Figure 1, Item 5), washer (Figure 1, Item 12) and nut (Figure 1, Item 11) and tighten.
7.
Position clevis (Figure 1, Item 8) onto park position caliper lever (Figure 1, Item 6).
8.
Install shoulder bolt (Figure 1, Item 7) and nut (Figure 1, Item 14).
9.
Connect electrical connector (Figure 1, Item 13).
10.
Connect battery negative cables (WP 0111).
11.
Perform Maintenance Operation Check.
12.
Install center access panel (WP 0028).
END OF TASK
00852