0025 00
TM 1-1730-227-13&P
REMOVAL CONTINUED
4.
Remove tire and hub (Figure 1, Item 5) from axle.
5.
Remove inner grease seal (Figure 1, Item 3) and inner bearing cone (Figure 1, Item 2) from tire and hub
(Figure 1, Item 5).
6.
Drive inner and outer bearing cups (Figure 1, Item 1 and 4) from tire and hub (Figure 1, Item 5).
INSTALLATION
1.
Drive the inner bearing cup (Figure 1, Item 4) and outer bearing cup (Figure 1, Item 1) into the tire and hub
(Figure 1, Item 5) until they bottom out in the tire and hub (Figure 1, Item 5).
2.
Insert inner bearing cone (Figure 1, Item 2) into the tire and hub (Figure 1, Item 5) and drive a new inner
grease seal (Figure 1, Item 3) into the tire and hub (Figure 1, Item 5) making certain that the inner grease seal
(Figure 1, Item 3) does not become cocked in the tire and hub (Figure 1, Item 5).
3.
Slide tire and hub (Figure 1, Item 5) with inner and outer bearing cups (Figure 1, Item 1 and 4), inner bearing
cone (Figure 1, Item 2) and grease seal (Figure 1, Item 3) installed, on rear axle shaft or front axle and king
pin pivot assembly.
4.
Install outer bearing cone (Figure 1, Item 6), thrust washer (Figure 1, Item 10), and slotted hex nut (Figure 1,
Item 9) on axle shaft.
5.
Tighten slotted hex nut (Figure 1, Item 9) while rotating the tire until a noticeable drag is felt. Back off the nut
(Figure 1, Item 9) about 1/8 turn to the nearest cotter pin slot.
6.
Install cotter pin (Figure 1, Item 7) and bend open end to keep it in place.
7.
Install hub cap.
END OF WORK PACKAGE
0025 00-2