TM 1-1730-227-13&P
0026 00
DISASSEMBLY CONTINUED
4.
Remove the shoe assembly (Figure 2, Item 5) with the spring from the front of the mounting plate . Remove
the spring from the brake lining.
5.
Remove the camshaft assembly (Figure 2, Item 9) and the two washers (Figure 2, Item 10).
ASSEMBLY
1.
Install camshaft assembly (Figure 2, Item 9) with one washer (Figure 2, Item 10) on each side of the mounting
plate (Figure 2, Item 11).
2.
Spread the brake shoe assembly (Figure 2, Item 5) and position with the camshaft assembly (Figure 2, Item
9) between wear plates on the brake shoe assembly (Figure 2, Item 5).
3.
Install compression spring (Figure 2, Item 6) and clip (Figure 2, Item 7) into shoe assembly. Push on com-
pression spring (Figure 2, Item 6) and clip (Figure 2, Item 7) and then insert spring pin (Figure 2, Item 4)
through clip (Figure 2, Item 7) and into the groove on back side of mounting plate (Figure 2, Item 11).
4.
Install pedal assembly (Figure 2, Item 14) on camshaft assembly (Figure 2, Item 9) then position the sector
(Figure 2, Item 3) in the pedal assembly (Figure 2, Item 14) as noted during disassembly, Step 1.), and secure
the pedal assembly (Figure 2, Item 14) to the back of the mounting plate (Figure 2, Item 11) with two lock
washers (Figure 2, Item 1) and screws (Figure 2, Item 2). Tighten all screws to a torque of 11 ft-lbs.
5.
Install tension spring (Figure 2, Item 8) on brake shoe assembly (Figure 2, Item 5). Note that the brake
assembly is self-adjusting.
END OF WORK PACKAGE
0026 00-3/4 blank