TADS POWER SUPPLY ASSEMBLY REPAIR (cont)

TADS POWER SUPPLY ASSEMBLY REPAIR (cont) - TM-1-1270-476-30_452

Section XIII. LASER ELECTRONICS UNIT (LEU) ASSEMBLY REPAIR

TM-1-1270-476-30 Aviation Intermediate Manitenance Manual Target Acquisition Designation Sight (TADS) Assembly AN/ASQ-170
Page Navigation
441

TM 1-1270-476-30 4-363 4-42. TADS POWER SUPPLY ASSEMBLY REPAIR (cont) 10. CONNECTOR J3 CONTACT REPLACEMENT CAUTION Leads for connector J3 may be damaged if mishandled. If lead length is too short for contact replacement, refer to the next higher level of maintenance. a. Remove access cover (1 above). b. Remove power components assembly (3 above). c. Remove cap (1). d. Remove four screws (2), four washers (3), and pull connector J3 (4) out of mounting hole for access. e. Remove faulty contact(s) (para 2-5). INSTALLATION f. Install replacement contact(s) (para 2-5). g. Install connector J3 (4) in chassis (5) with four screws (2) and four washers (3). h. Have Installation Inspected. i. Install power components assembly (3 above). j. Install cap (1). k. Install access cover (1 above). END OF TASK

Privacy Statement
Press Release
Contact