TM 1-1270-476-30
4-258
4-30. HEADS OUT DISPLAY (HOD) ASSEMBLY REPAIR (cont)
l. Install air vent assembly (3) by installing six
screws (4) and washers (5).
m. Install front plate assembly (1) by installing
four screws (2).
n. Install video output and focus CCA (2
above).
o. Install vertical output and width regulator
CCA (1 above).
p. Perform followup.
END OF TASK
4. YOKE ASSEMBLY REPLACEMENT
REMOVAL
a. Remove CRT assembly (3 above).
b. Disconnect connector P4 (1) by loosening
two screwlocks (2).
c. Remove yoke assembly (3).
INSTALLATION
d. Install yoke assembly (3).
e. Connect connector P4 (1) to J4 (4) and
tighten two screwlocks (2).
f. Install CRT assembly (3 above).
g. Perform followup.
END OF TASK
