TM 55-1680-320-23 & P
3-22. CLUTCH ASSEMBLY - ADJUST (cont)
3-22
6. If torque required to slip clutch roller exceeds 25 in-lbs. proceed as follows:
a.
b.
c.
Disassemble clutch assembly in accordance with Task 3-21.
NOTE
Removal of clutch aissembly shims lowers torque required to cause clutch roller slippage.
Remove clutch assembly shim(s) as required to adjust clutch torque.
Reassemble clutch assembly and repeat steps 1 through 4 to ensure proper operation.
7. If clutch roller slippage occurrs at less than 21 in-lbs. proceed as follows;
a.
b.
c.
Disassemble clutch assembly in accordance with Task 3-21.
NOTE
Addition of clutch assembly shims raises torque required to cause clutch roller slippage.
Add clutch assembly shim(s) as required to adjust clutch torque.
Reassemble clutch assembly and repeat steps 1 through 4 to ensure proper operation.
FOLLOW-ON MAINTENANCE:
Install clutch assembly
(Task 3-23)
END OF TASK
3-79