TM 55-1650-320-23 & P
2-58. CABLE HOOK ASSEMBLY - REPLACE (cont)
2-58
b.
c.
d.
e.
f.
Remove carrier assembly lock spring (1) from
upper carrier (2), Separate carrier halves (2,
3).
Pull cable hook (4) out of upper carrier (2).
Remove cap seal (5) from upper carrier (2).
Remove and discard packing (6).
Insert flat tip screwdriver through hole in top
of disc (10) and push retainer (7) from carrier
(2). Remove retainer from cable by removing
packing (8). Discard packing.
Pull cable through upper carrier (2), cylinder
(9) and disc (10).
2. Installation.
a.
b.
c.
d.
e.
f.
Insert cable through disc (10), cylinder (9)
and upper carrier (2).
Close retainer (7) around cable. Lubricate
packing (8) and install onto assembled retainer.
Grasp cable at top of upper disk (10), and
pull until retainer (7) slides into recess of car-
rier (2).
Lubricate packing (6) and install on cap seal
(5). Install cap seal into carrier (2) with flat
side of cap seal up.
Install cable hook (4) into upper carrier (2).
Screw together carrier halves (2, 3). Install
carrier assembly lock spring (1).
FOLLOW-ON MAINTENANCE:
Conduct performance test
(Task 2-7)
END OF TASK
2-124
