TM 55-1680-320-23 & P
2-57. CABLE HOOK ASSEMBLY - REPAIR (cont)
2-57
4.
5.
e. Inspect torsion spring for distortion.
Repair. Repair of parts is limited to the romoval
of minor nicks, burrs, scratches or other surface
damage using aluminum oxide cloth or fine
abrasive. Clean parts thoroughly after repair. If
damage is extensive, or if minor repair will affect
serviceability, replace the part.
Reassembly.
a.
b.
c.
d.
e.
NOTE
Carrier assembly (2, 7) is a matched
set. Replace only as an assembly.
Insert torsion spring (12) with release pin (10)
and bushing (11) into cable hook (8).
Install cable hook keeper (9) onto cable hook
(8) using rivet (13).
Install bearing retainer (7) and bearing (6) onto
hook (8).
Install split retainer (5) onto hook (8) and slide
into bore of bearing (6).
Install striker disk (1) and carrier assembly
(2) into cylinder (3).
FOLLOW-ON MAINTENANCE:
Install cable hook assembly
(Task 2-58)
END OF TASK
2-122