0127
TM 1-1740-221-13&P&P
THROTTLE RESERVOIR - (CONTINUED)
REMOVAL
WARNING
The use of Personal Protective Equipment (PPE) is required when using or handling hazardous
materials associated with operating and maintaining equipment (jet fuel, hydraulic luid, brake
luid, ethylene glycol, cleaning solvents, compressed air, and engine/axle oil). Failure to use
PPE when handling these materials could result in injury or death.
1.
Chock wheels.
2.
Disconnect negative battery cables (WP 0111).
3.
Remove driver seat (WP 0028).
4.
Open engine access cover (WP 0028).
5.
Place a drip pan under throttle reservoir.
6.
Remove throttle reservoir hose (Figure 1, Item 3) and plug.
7.
Cap reservoir itting (Figure 1, Item 4) or allow reservoir to drain.
8.
Remove reservoir itting (Figure 1, Item 4) and save for reinstallation.
9.
Remove nut, washer and screw (Figure 1, Item 5).
10.
Remove throttle reservoir (Figure 1, Item 2).
11.
Remove reservoir clamp (Figure 1, Item 6) from reservoir and save for reinstallation.
END OF TASK
INSTALLATION
1. Position reservoir clamp (Figure 1, Item 6) on the reservoir.
2. Position the throttle reservoir (Figure 1, Item 2).
3. Install screw, washer and nut (Figure 1, Item 5) and tighten.
4. Wrap reservoir itting (Figure 1, Item 4) with anti-seize tape.
5. Install reservoir itting (Figure 1, Item 4).
6. Install the throttle reservoir hose (Figure 1, Item 3) and tighten.
7. Service reservoir and perform throttle system bleed (WP 0124).
8. Install driver seat (WP 0028).
9. Connect battery negative cables (WP 0111).
10. Remove wheel chocks.
11. Perform Maintenance Operation Check.
12. Close engine access cover (WP 0028).
END OF TASK
END OF WORK PACKAGE
01273/blank
