TM 1-1740-221-13&P&P
FIELD MAINTENANCE
TURN SIGNAL LIGHT
INITIAL SETUP:
Test Equipment
Personnel Required
Multimeter (WP 0157, Item 14)
91B, Light Wheel Vehicle Mechanic
Tools and Special Tools
Equipment Condition
Engine Shut Down
General Mechanics Tool Kit (WP 0157, Item 24)
INSPECTION
1. Visually inspect sealed headlight for cracks, loose connections, or condensation buildup in light. Replace as
necessary.
2. Check for 12 VDC at appropriate harness with ignition switch on and turn signal light lever actuated. If
voltage is present, replace turn signal light.
END OF TASK
REMOVAL
NOTE
Turn signal light is a sealed assembly, when required replace entire assembly.
1.
Remove four bolts (Figure 1, Item 1) and four nuts (Figure 1, Item 2) securing guard (Figure 1, Item 3) to
tow vehicle.
2.
Tag and disconnect harness (Figure 2, Item 2) from turn signal light (Figure 2, Item 1).
3.
Push turn signal light (Figure 2, Item 1) and grommet (Figure 2, Item 3) from tow vehicle.
Figure 1. Turn Signal Light Guard.
01161