0115
TM 1-1740-221-13&P&P
DIRECTIONAL SIGNAL ARM - (CONTINUED)
1.
Position directional signal arm assembly.
2.
Install mount clamp (Figure 3, Item 1).
3.
Carefully route wiring harness (Figure 1, Item 2) to center console area.
4.
Connect remaining 5 wiring harness connectors (Figure 2) from under the center console area under the
vehicle.
NOTE
Wire tie the harness as previously noted to prevent excessive chafing or damage.
5.
Connect horn wire (Figure 1, Item 1).
6.
Install orbital valve cover panel (WP 0136).
7.
Connect battery negative cables (WP 0111).
8.
Perform Maintenance Operation Check.
END OF TASK
END OF WORK PACKAGE
01153/blank