0094
TM 1-1740-221-13&P&P
SPRING ASSEMBLY (FRONT AND REAR) - (CONTINUED)
1.
Chock front wheels.
2.
3.
4.
5.
Position loor jack under the axle end assembly and apply pressure to the axle.
6.
7.
Remove 1 rear leaf mount bolt and nut (Figure 2, Item 8).
8.
Remove 2 front leaf mount bolts and nuts (Figure 2, Item 1 and 3) and remove bolts.
9.
Remove 4 spring mount bolts, washers and nuts (Figure 2, Item 4 and 5) and remove bolts.
10.
Remove spring plate (Figure 2, Item 6).
11.
12.
Lower axle jack 1 to 2 inches.
13.
Remove spring assembly (Figure 2, Item 9).
END OF TASK
INSTALLATION
FRONT SPRINGS
1. Position spring assembly in the shackles (Figure 1, Item 5 and 9).
2. Install leaf mount bolt (Figure 1, Item 6) and nut (Figure 1, Item 7) and tighten
3. Raise axle jack and apply pressure to the spring assembly.
4. Install spring plate (Figure 1, Item 3) on aligning pin.
5. Install 4 spring mount bolts (Figure 1, Item 1) and washers (Figure 1, Item 2) and tighten.
7. Install 2 axle mount nuts and washers (WP 0075).
11. Perform Maintenance Operation Check.
REAR SPRINGS
1. Position spring assembly (Figure 2, Item 9) in the shackles.
2. Install rear leaf mount bolt and nut (Figure 2, Item 8) and tighten.
3. Install 2 front leaf mount bolts and nuts (Figure 2, Item 1 and 3) and tighten.
4. Raise axle jack and apply pressure to the spring assembly.
5. Install spring plate (Figure 2, Item 6) on aligning pin.
6. Install 4 spring mount bolts, washers and nuts (Figure 2, Item 4 and 5) and tighten.
00943