0089
TM 1-1740-221-13&P&P
HAND BRAKE CABLE - (CONTINUED)
1.
Disconnect battery negative cables (WP 0111).
2.
Remove center deck plate (WP 0028).
3.
Jack vehicle (WP 0029).
4.
Remove 4 screws (Figure 1, Item 12).
5.
Remove cotter pin (Figure 1, Item 3).
6.
Remove washer (Figure 1, Item 2).
7.
Remove clevis pin (Figure 1, Item 1).
8.
Remove nuts (Figure 1, Item 6).
9.
Remove bolts (Figure 1, Item 11).
10.
Remove clamp assembly (Figure 1, Item 5 and 10).
11.
Remove cotter pin and clevis pin (Figure 1, Item 9).
12.
Remove clevis assembly (Figure 1, Item 8) from caliper.
13.
Loosen jam nut (Figure 1, Item 7).
14.
Remove hand brake cable assembly (Figure 1, Item 4).
END OF TASK
INSTALLATION
1. Position hand brake cable assembly (Figure 1, Item 4).
2. Install clevis pin (Figure 1, Item 1).
3. Install washer (Figure 1, Item 2).
4. Install cotter pin (Figure 1, Item 3).
5. Install clamp assembly (Figure 1, Item 5 and 10).
6. Install bolts (Figure 1, Item 11).
7. Install nuts (Figure 1, Item 6).
8. Install 4 screws (Figure 1, Item 12).
9. Route brake cable assembly (Figure 1, Item 4) to hand brake caliper.
10. Position clevis assembly (Figure 1, Item 8) on caliper lever.
11. Install clevis pin and cotter pin (Figure 1, Item 9).
12. Tighten jam nut (Figure 1, Item 7).
13. Install center plate (if removed) (WP 0028).
14. Lower vehicle (if raised) (WP 0029).
15. Connect battery negative cables (WP 0111).
16. Perform Maintenance Operation Check.
END OF TASK
END OF WORK PACKAGE
00892