0043
TM 1-1740-221-13&P&P
TRANSMISSION - (CONTINUED)
NOTE
Nut has a detent that must be straightened before you can loosen nut.
14. Remove stake nut (Figure 2, Item 3), and washer (Figure 2, Item 1) and remove pre-installed drive shaft disc
(Figure 2, Item 2) from transmission.
15. Place the park position/hand brake caliper bracket in position and secure with 8 mounting bolts. Torque
to 85 ft-lbs (Figure 3, Item 2).
16. Reinstall drive shaft disc (Figure 2, Item 2) and secure with existing washer (Figure 2, Item 1) and stake nut
(Figure 2, Item 3). Torque nut to 221 ft-lbs.
17. Stake nut on shaft with hammer and punch at notch (Figure 2).
18. Install hand brake caliper assembly (WP 0090).
19. Install 2 threaded rods (Figure 1, Item 4 and 5) on park position bracket to transmission mounting bracket.
20. Tighten nuts (Figure 1, Item 2 and 3) to secure.
22. Install engine power pack in engine cradle (WP 0032).
23. Install power pack assembly in vehicle (WP 0031).
24. Perform Maintenance Operation Check.
END OF TASK
END OF WORK PACKAGE
00439/blank