0043
TM 1-1740-221-13&P&P
TRANSMISSION - (CONTINUED)
Figure 8.
Fittings and Wiring
21. Remove all ittings (Figure 8, Item 1) (note orientation).
22. Tag and remove electrical wiring harness from solenoid connectors (Figure 8, Item 2). Save for reinstallation
on new transmission.
END OF TASK
INSTALLATION
NOTE
If transmission is being replaced it is recommended maintainers replace the torque converter
(WP 0045) at the same time.
When installing a new transmission, use the old dipstick tube because it was modiied during
initial installation.
1.
Install all ittings (Figure 8, Item 1) in correct position as previously noted.
2.
Install electrical wiring harness (Figure 8, Item 2) in correct position as tagged.
3.
Position trans lift weldment (Figure 5, Item 3) onto the eyelets of the transmission (Figure 5, Item 2).
00437