TM 1-1730-232-13&P
3-16.7 Wheel Assembly Replacement, Model 214-706-104-101 (AVUM).
The Wheel Assembly is group number 03 in the MAC. This procedure is applicable to wheel assembly with part number
40-117A, used on Ground Handling Wheels Assembly, Model 214-706-104-101. The numbers in parenthesis refer to
figure 3-17. Observe all WARNINGS and CAUTIONS while performing the following inspections.
This task covers:
a.
Remove
INITIAL SETUP
Tools
Tool Kit, Aircraft Mechanics General, NSN 5180-00-323-4692
Tire Pressure Gauge
Materials
Grease P/N MIL-G-10924 (item 7, Appendix D)
Repair Parts
Wheel Half, Outer .......................................................... P/N 162-48
Wheel Half, Inner. .......................................................... P/N 161-23
Tire
.......................................................................... P/N MS26535-2
Tube, Pneumatic ........................................................... P/N ZZ-1-550/G5/5.70/5.00-8/OFFCTR
Ring, Retaining. ............................................................. P/N 155-1
Washer, Flat .................................................................. P/N 153-4
Retainer, Packing........................................................... P/N 153-15
Bearing ......................................................................... P/N 214-1 and 214-2
Seal
.......................................................................... P/N 153-3
Felt, Mechanical............................................................. P/N 154-01300
Personnel Required
MOS 67
A. REPAIR
WARNING
To prevent personnel injury, the tire and tube must be completely deflated, and the valve stem
cores removed, before attempting to separate the wheel halves in the following procedures.
GO TO NEXT PAGE
3-49
