TM 1-1730-232-13&P
3-17.2 Wheel Assembly Inspection, Model 1730-EG-100 (AVUM).
The Wheel Assembly is group number 03 in the MAC This procedure is applicable to Ground Handling Wheels
Assembly, Model 1730-EG-100. Inspect the wheel assembly as follows,
Figure 3-20. Wheel Assembly for Model 1730-EG-100
1.
Check for cracked rims (1 & 2), missing parts, or damage to wheel assembly. If damaged, replace
wheel assembly using procedures in paragraph 3-17.6 or repair wheel assembly using procedures in
paragraph 3-17. 7.
2.
Check for cut, worn, or frayed tires (3). If a tire is defective, replace wheel assembly using procedures
in paragraph 3-17.6 or repair wheel assembly using procedures in paragraph 3-17.7.
3.
Check for grease leaking from wheel assembly bearings (11 & 12). If leaking grease, replace wheel
assembly using procedures in paragraph 3-17.6 or repair wheel assembly using procedures in
paragraph 3-17.7.
4.
Check that wheel rotates freely on axle. If wheel rotation is sluggish and the axle is okay, replace
wheel assembly using procedures In paragraph 3-17.6 or repair wheel assembly using procedures in
paragraph 3-17.7.
WARNING
Never inflate wheel assembly without first checking wheel locknut torques, to insure wheel
locknuts are tightened to specifications. An assembly with missing washers, bolts, nuts or
improperly tightened locknuts could separate under pressure, causing serious injury or death.
5.
Check tire air pressure with tire pressure gauge for 75 psi (51.7 kPa). Inflate tube (4) if necessary,
using available air source or deflate to proper pressure.
END OF TASK
3-54
