TM 1-1730-232-13&P3-15.3 Wheel Assembly Inspection, Model 204-050-200-5 (AVUM).The Wheel Assembly is group number 03 in the MAC. This procedure is applicable to Ground Handling WheelsAssembly, Model 204-050-200-5 The numbers in parenthesis refer to figure 3-4 Inspect the wheel assembly as follows:Figure 3-4. Wheel Assembly for Model 204-050-200-51. Check for cracked rims (1 & 2) and missing parts (5, 6, 7) on wheel assembly. If damaged, replace wheel assemblyusing procedures in paragraph 3-15.6 or repair wheel assembly using procedures in paragraph 3-15.7. Replace anymissing parts.2. Check for cut, worn, or frayed tires (3). If a tire is defective, replace wheel assembly using procedures in paragraph 3-15.6 or repair wheel assembly using procedures in paragraph 3-15.7.3. Check for grease leaking from wheel assembly bearing packing retainers (4 or 5). If leaking grease, replace wheelassembly using procedures in paragraph 3-15.6 or repair wheel assembly using procedures in paragraph 3-15.7.4. Check that wheel rotates freely on axle. If wheel rotation is sluggish, replace wheel assembly using procedures inparagraph 3-15.6 or repair wheel assembly using procedures in paragraph 3-15.7.5. Check tire air pressure with tire pressure gauge for 50 psi (34.5 kPa). Inflate if necessary, using available air sourceor deflate to proper pressure.END OF TASK3-17
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
