TM 1-1270-476-30
4-343
4-40. TADS ELECTRONIC UNIT (TEU) ASSEMBLY REPAIR (cont)
m. Remove old corrosion inhibitive sealing and
coating compound from mounting hardware
(para 2-6).
n. Apply corrosion inhibitive sealing and
coating compound to mounting hardware
(para 2-6). Use class 1A application.
CAUTION
Do not try to bend flexible printed cable unless
heated. Do not overheat. Too much heat will
damage printed cable.
NOTE
A heat source of approximately 200°F is best
to make cable soft and bend easily. Holding
heat gun approximately 5 inches away from
the point you want to heat will usually apply
about 200°F.
o. Install front panel (3) using two mounting
brackets (5), six washers (4), and screws
(2).
p. Apply corrosion inhibitive sealing and
coating compound to mounting brackets (5)
and hardware (para 2-6). Use class 1
application.
q. Install safety wire (1) on upper right screw
(2).
r. Install power supply assembly A14 (3
above).
s. Install cover (1 above).
END OF TASK
