TM 1-1270-476-30 4-185 4-14.  WIRING HARNESS ASSEMBLY (W1) REPAIR (cont) REMOVAL NOTE If replacing connector P13, omit steps a and e. a.  Cut lacing and tying tape (1) and disconnect applicable connector. Mating Connector Connector P3 1A5A13J1 P6 1A5A15J1 P9 1A5A14J1 P10 1A5A16J1 P11 1A5A17J1 P12 1A5A18J1 P13 1A5A4J1 P14 1A5A19J2 P15 1A5A20J1 P16 1A5A20J2 P17 1A5A21J1 J1 1A5A12P1 J2 1A5A12P2 J3 1A5A11P3 J4 1A5A11P2 J5 1A5A11P1 b.  Cut and remove lacing and tying tape from wire bundle as required to provide service loop to replace connector. c.   Remove applicable connector from wiring harness (para 2-5). INSTALLATION d.  Install applicable replacement connector on wiring harness (para 2-5). e.  Connect applicable connector and secure using lacing and tying tape (1). Mating Connector Connector P3 1A5A13J1 P6 1A5A15J1 P9 1A5A14J1 P10 1A5A16J1 P11 1A5A17J1 P12 1A5A18J1 P13 1A5A4J1 P14 1A5A19J2 P15 1A5A20J1 P16 1A5A20J2 P17 1A5A21J1 J1 1A5A12P1 J2 1A5A12P2 J3 1A5A11P3 J4 1A5A11P2 J5 1A5A11P1 f.    Install lacing and tying tape required on wire bundle. END OF TASK