TM 1-1270-476-30
4-187
4-14. WIRING HARNESS ASSEMBLY (W1) REPAIR (cont)
3. CONNECTOR P5, P7, J7 THRU J9
REPLACEMENT
REMOVAL
NOTE
If replacing connector P7, J7 thru J9, omit
steps a and e.
a. Loosen two screwlocks (1) and disconnect
applicable connector (2).
Mating
Connector
Connector
P5
1A5A4J2
b. Cut and remove lacing and tying tape from
wire bundle as required to provide service
loop to replace connector.
NOTE
If connector P5 or P7, is being replaced, retain
two screwlocks (1) from damaged connector
for installation on replacement connector.
c. Remove applicable connector from wiring
harness (para 2-5).
INSTALLATION
d. Install applicable connector on wiring
harness (para 2-5).
Mating
Connector
Connector
P5
1A5A4J2
e. Connect connector (2) to mating connector
and tighten two screwlocks (1).
f. Install lacing and tying tape as required on
wire bundle.
END OF TASK
