TM 55-1680-320-23 & P
2-48. WINCH ASSEMBLY - REPAIR (cont)
2-48
i
k.
1.
m
n.
o.
P.
Lubricate packing (15) and install onto motor
flange (16). Install inertia dump assembly
(17).
Install coupling (14) onto motor mount adapter
plate (18). Align pin on adapter plate with
hole on motor end bell.
Install motor (13) onto adapter plate (18), en-
suring splined end of motor meshes with inertia
dump assembly (17). Secure by tightening
coupling (14).
Install motor abduct (9) using bolts (12). At-
tach boot (18) using bands (10) and clips (11).
Install limit switch drive assembly (5) using
screws (6) and washers (7). Torque screws
to 12-15 in.lbs.
NOTE
Limit switch drive screws (6) may be
loosened to assist in the installation
of roller chain (4). Tighten screws (6)
after installation.
Position unconnected roller chain (4) onto
sprockets (41). Connect chain by installing
master link.
Apply locktite compound to threads of screws
(2). Install chain guard cover (1) using screws
and washers (3). Torque screws to 12-15
in.lbs.
GO TO NEXT PAGE
2-103
