TM 55-1680-320-23 & P
2-43. WINCH ASSEMBLY - REPAIR (cont)
2-48
h
i.
j.
k.
l
m.
Remove screws (19, 20), washers (21, 22) and
nuts (23).
Carefully remove assembled cover (24) and
drum (25) from winch housing (26).
Remove retaining ring (27) and shim (28).
Using a 10-32 screw, remove retainer (29) and
level wind shoe (30) from drum (25).
Remove connector (31 ) by removing screws
(32) and clamp (33). Using a suitable pin
removal tool, remove pins from connector.
Remove heat shrink tubing and braid from
switch (34). Unscrew switch from cover (35).
Remove lockwire from drain plug (36). Re-
move drain plug. Remove and discard packing
(37).
n. Remove lockwire from breather assembly
(38). Remove breather assembly. Remove
and discard packings (39, 40).
2. Cleaning.
Use solvent in a well ventilated area.
Avoid prolonged breathing of fume.
Keep away from open flame. Use
approved safety equipment.
Use approved personnel protective
equipment (goggles/face shield) when
using compressed air, Air pressure is
restricted to a maximum of 35 psi. Do
not direct airstream towards self or
other personnel as injury may occur.
GO TO NEXT PAGE
2-100
