0074
TM 1-1740-221-13&P&P
EXHAUST PIPES - (CONTINUED)
8.
Remove rear exhaust pipe (Figure 1, Item 6).
FORWARD EXHAUST PIPE
1. Disconnect battery negative cables (WP 0111).
2. Remove center deck plate (WP 0028).
3. Remove mufler (WP 0073).
NOTE
To prevent FOD cover turbo exhaust outlet on engine.
4.
Remove 4 exhaust mount bolts (Figure 1, Item 1) (one not shown).
5.
Remove engine exhaust weldment pipe (Figure 1, Item 2).
6.
Discard old gasket (Figure 1, Item 10).
7.
Clean exhaust weldment pipe lange mating surface.
END OF TASK
INSTALLATION
REAR EXHAUST PIPE
1. Position rear exhaust pipe (Figure 1, Item 6) over mufler outlet tube and in hanger clamp.
2. Position the mufler outlet exhaust pipe clamp (Figure 1, Item 5) and tighten.
3. Position the ilter guard (Figure 1, Item 8).
4. Install 2 ilter guard clamps (Figure 1, Item 9) (one not shown) and tighten.
5. Position the tail pipe hanger clamp (Figure 1, Item 7) and tighten.
6. Connect battery negative cables (WP 0111).
7. Perform Maintenance Operation Check.
8. Install center deck plate (WP 0028).
FORWARD EXHAUST PIPE
1. Position new gasket (Figure 1, Item 10) and engine exhaust weldment pipe (Figure 1, Item 2).
2. Install 4 exhaust mount bolts (Figure 1, Item 1) (one not shown). Torque to 35-38 ft. lbs..
3. Install mufler (WP 0073).
4. Connect battery negative cables (WP 0111).
5. Perform Maintenance Operation Check.
6. Install center deck plate (WP 0028).
END OF TASK
END OF WORK PACKAGE
00742