0005 00
TM 1-1730-215-13&P
PREPARATION FOR MOVEMENT
CAUTION
Failure to open and close the vent plug as prescribed will result in failure of the hydraulic pump,
gasket and seals.
1.
The platform assembly is equipped with casters to permit easy movement. These casters are equipped with
locks to prevent swiveling and two are provided with brakes to prevent movement when the platform is in
use. When in a work position, all casters must be locked.
2.
The platform is equipped with elevation lock pins to prevent accidental lowering. These pins must be installed
before working from the platform.
3.
The platform can be moved by towing with a vehicle. The platform must be lowered before towing, and a
speed of 5 MPH should never be exceeded.
MOVING THE PLATFORM
CAUTION
When operating the maintenance platform under usual conditions it is always necessary to
open and close the vent plug located on the pump assembly. To disregard this instruction will
result in early failure of pump gaskets and seals.
1.
The platform should be positioned in the desired location before raising.
NOTE
The swivel casters are equipped with spring loaded lock pins. When engaged, these lock the
casters in 90 degree increments.
2.
When preparing to position the platform, unlock the casters (Figure 1, Item 5) on all four wheels and release
the brakes (Figure 1, Item 6) on the two rear casters.
3.
When in position lock all the casters (Figure 1, Item 5) and set the brakes (Figure 1, Item 6).
RAISING THE PLATFORM
1.
Remove both safety lock pins (Figure 1, Item 1). Stow pins.
CAUTION
Failure to open and close the vent plug as prescribed will result in failure of the hydraulic pump,
gasket and seals.
2.
Open vent plug (Figure 1, Item 2).
3.
Close the release valve lever (Figure 1, Item 3).
4.
Operate pump handle (Figure 1, Item 4) until platform reaches the desired height.
5.
Reinstall safety lock pins (Figure 1, Item 1).
6.
Close vent plug (Figure 1, Item 2).
0005 00-2
