TM 1-1270-476-30
4-213
4-23. DAY SENSOR SHROUD ASSEMBLY REPAIR (cont)
INSTALLATION
e. Remove old liquid adhesive from shroud
assembly (5) (para 2-6).
f. Apply liquid adhesive to thermostatic switch
S1 (2) and shroud assembly (5) (para 2-6).
g. Tape thermostatic switch S1 (2) to shroud
assembly (5). Leave taped until liquid
adhesive is cured, then remove tape.
h. Slide new heat shrinkable insulation
sleeving (3) onto wires (4).
i. Solder wires (4) to thermostatic switch S1
(2) and remove tags.
j. Have installation inspected.
CAUTION
When applying heat to heat shrinkable
insulation sleeving, take care to avoid
damaging other components with excessive
heat.
k. Slide new heat shrinkable insulation
sleeving (3) over connections and shrink,
using heat gun.
l. Install lacing and tying tape (1) as required.
END OF TASK
