TM 55-1680-320-23 & P
3-13. CONTROL PENDANT ASSY - REPAIR (cont)
3-13
5. Reassembly.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l .
Install connector (35) onto grip (37) and secure using mews (36).
Install bracket (32) and terminal lug (33) and secure using screws (34).
Connect electrical wiring to intercom switch, Install intercom switch (29) onto bracket (32) and secure using
attaching nut (30) and washer (31).
Install trigger (26) and secure using pin (28) and setscrew (27). Fill setscrew hole with adhesive.
Install thumbwheel (24) and spring (25).
Coat threads of screws (21, 23) with adhesive. Install bearings (20, 22) using screws (21, 23).
Connect electrical wiring and insert pin (19) into potentiometer (18). Install potentiometer by aligning pin with
slot in bearing (20) Push in and turn. Coat threads of screws (17) with adhesive and install.
Coat threads of screws (16) with adhesive. Install retainer (15) using screws (16) and safety wire using lockwire.
Coat threads of screws (12) with adhesive. Install plates (13), switches (11) and balls (14) and secure using screws
(12). Safety wire screws using lockwire.
Connect electrical wiring to boom position switch (8). Install switch and secure using attaching nut (9) and washer
(10).
NOTE
Ensure caution (amber) and overtemp (red) lights are installed in correct light bodies on pendant assembly.
Connect electrical wiring to indicator light bodies (5). Install light bodies
washers (7). Install lights (3, 4).
Install cover (1) and secure using screws (2). Seal cover with adhesive.
FOLLOW-ON MAINTENANCE:
Install control pendant
(Task 2-16)
conduct performance check
(Task 3-7)
and secure using attaching nuts (6) and
GO TO NEXT PAGE
3-50
